The X-310™ is a robust, full-featured Ethernet I/O module. It is also fully web-enabled. In total, it has four 1Amp relays and four optically-isolated digital inputs. Up to four temperature or humidity sensors can be supported at one time and it can also control up to 16 remote relays.
HWg-WLD is an IP based water sensor with water leak detection cable. The product features a Web server, SNMP support, e-mail alerts. HWg-WLD can control remote relay outputs over IP (switch remote relay ON/OFF if water leak is detected).
The Kvaser Leaf Light supports full speed USB interface for CAN with high performance at a low cost. Loss free transmission and reception of standard and extended CAN messages on the CAN bus is transmitted with a time stamp precision of 100 microseconds.
The Kvaser Leaf Light v2 represents one of the easiest and lowest-cost methods of connecting a computer to a CAN bus network With its USB 2.0 compliant connector and 9-pin D-SUB connector, the Leaf Light v2's sleek, ergonomically designed housing is both robust enough for everyday use and small and flexible enough to be used in space-constrained applications. Now with galvanic isolation as standard.
Labjack UE9 USB/Ethernet data acquisition unit with analogue and digital I/O unit for data logging, data acquisition, measurement and control applications. Supports MODBUS/TCP for industrial applications. Available with a wide range of FREE Data logging and oscilloscope software and examples for use with most programming and DAQ packages
The X-300-I Advanced Industrial Temperature Module allows for web-based temperature monitoring and logging. It can collect data from up to 8 Sensors. Enclosure can be mounted on a DIN Rail. For more advanced configurations, BASIC script programming is supported. It also sends out e-mail alerts and notifications when certain events occur.
The X-320™ is a high-end, web-based instrumentation module. It can be used in a numerous amount of applications, both scientific and industrial. Some of these applications include energy/power monitoring, meteorology, process control, etc. The module has 4 Analog In inputs, 2 digital i/o inputs and 1 wire and frequency inputs.
Outputs a voltage from -10V to +10V. The PhidgetAnalog 4-Output Produces a voltage over -10V to +10V. This voltage will be asserted up to +-20mA. An error will be reported when this current is exceeded, and the voltage the customer is getting is no longer accurate. The voltage is produced with 12 bit resolution (4.8mV). The board is not isolated and all 4 channels share a common ground. All the power is supplied by the USB bus.